Bluesolar MPPT 75/15

Feature: 1. Strong Practicability: 600W solar grid tie inverter is a device that converts direct current generated by solar panels into alternating current, and is mainly used in solar power generation systems. 2. Aluminum Alloy Material: Solar Micro inverter is made of aluminum alloy material, which has good heat dissipation, rust and corrosion resistance, and can be used for a long time. 3. High Conversion Rate: MPPT grid tie inverter has high conversion efficiency, the highest conversion efficiency can attain 92.5%, improving the use efficiency. 4. IP55 Waterproof: The 600W solar grid tie inverter has a waterproof rating of IP55, which can meet daily use and has a variety of protection methods, so you can use it with confidence. 5. Note for Use: Solar grid tie inverter needs to be connected to the grid before it can be used, and can only be used with solar panels, not batteries.

Specification: Item Type: 600W Solar Grid Tie Inverter Material: Aluminum Alloy Inverter Box Size:Approx. 16.3 x 10.1 x 4cm / 6.4 x 3.9 x 1.6in Output Voltage Waveform: Sine Wave Photovoltaic Output (DC): Input Connector Quantity: 1 Set MPPT Voltage Range: 24-40V Operating Voltage Range: 18-50V Maximum Input Voltage: 50V Start Voltage: 18V Maximum Input Power: 600W Maximum Input Current: 24A AC Output (AC): Single Phase Grid Type: 230V Rated Output Power: 580W Maximum Output Power: 600W Rated AC Current: 230V: 2.52A Rated AC Voltage: 230V AC Output Voltage Range: 230V AC: 180V-280V Rated AC Frequency:: 50/60Hz Output Frequency Range: 50Hz：47.5-52.5Hz/60Hz：57.5-62.5Hz Output Power Factor: >0.99 Efficiency: The Highest Conversion Efficiency: 92.5% CEC Weighted Efficiency: 230V AC: 91.5% MPPT: Tracking Efficiency: 99.9% Night Loss: <700mW Temperature Range: -40°C to 65°C (ambient Temperature)/-40°C to 85°C (storage Temperature) Waterproof Grade: IP55 Communication: None Protection Mode: Island Protection, Voltage Protection, Frequency Protection, Temperature Protection, Current Protection, Etc. Comprehensive Grounding: the PE End of the AC Cable is the Grounding Wire of the Device, and There is No Other Grounding Port. Package List: 1 x 600W Solar Grid Tie Inverter 1 x AC Cable Note: 1. This device can only be connected to solar photovoltaic modules as an input source.2. This equipment is a grid connected power generation equipment. It must be connected to the power grid and the power grid works normally to generate electricity normally. When the power grid fails, the equipment will also stop generating electricity.3. Before use, please make sure that the open circuit voltage VOC and working voltage VMP of the photovoltaic modules are in line with the input voltage and working voltage range of the device.4. Before use, please ensure that the maximum output power of the photovoltaic modules does not exceed the maximum input power of the device.5. The DC power of the photovoltaic modules will pass through this equipment, and each circuit must be disconnected separately before maintenance or disassembly.6. Please do not cover any other objects on this device. Please do not open the casing. The maintenance of this device needs to be carried out by professionals.7. When the photovoltaic module is connected to the device and exposed to sunlight, it will supply DC power to the device, please pay attention to safety.8. Please do not install the device in a place where direct sunlight or rain and snow may be covered (such as the crack between two components should be avoided).